Are you looking for some tips for the installation of fiber optic cable? If so, you are on the right page. In this article, we have shared some tips that will help you with your fiber optic cable installation. Read on to find out more.
First of all, you should never pull on the fiber itself. The thing is that these cables have a fiberglass rod or Kevlar aramid yarn that dictates their strength number. Therefore, you should fall on only the strength numbers.
Apart from this, you need to consider the load rating when it comes to pulling. You should always use lubricants that are compatible with the jacket of the cable. In case of long runs, you should pull from the middle of the cable to both ends.
If you want to be on the safe side, you may want to go for an automated cooler that comes with adjustable tension control. Similarly, you may want to keep an eye on the load rating.
You may want to consider the bend radius of the cable. When it comes to pulling it straight, it can be stronger than steel. On the other hand, if you bend it too much, it will easily break. If you bend it too tightly, the fibers will be damaged.
You should not make the mistake of spinning the cable at the end of the pool. Instead, you should roll it off the spool. Twisting the fiber cable is one of the most common mistakes. If you put a twist, it will put undesirable stress on the fibers of the cable.
You may want to measure the cable to make sure it is long enough. It’s important to note that fiber splicing can make things complicated. So, you may want to pay special attention to this aspect.
As far as inner duct cables are concerned, you can install them directly. But make sure that you put the cables inside the inner duct. The thing is that the inner duct can help protect the cable against damage when someone tries to cut it by mistake.
Put together an installation plan before you get started. It is better that you create a detailed plan before initiating the installation. As a matter of fact, proper planning can help you avoid 95% of the common installation problems. Make sure that the plan covers all of the things, such as safety shoes, potential problem areas, installation methods, personal experience level, testing requirement, equipment location, and equipment supplies, just to name a few.
It is not a good idea to push fiber optic cables. Instead, you may want to use the pulling technique. The use of the wrong technique can damage the cable permanently.
Finally, you may want to use the right tools and techniques. After all, you may want to avoid as many mistakes as you can while installing these cables.
Long story short, if you follow these tips, you will be able to install fiber optic cables without making costly mistakes in the process.
Are you looking for the best fiber optic machine for the secondary coating line? If so, you can go to Shanghai Weiye. They can help you with SZ standing line as well.